Bosch Piezoelectric Injectors Valve - China

Jun Mandy whatsapp: +8615105944581

#Automatic Fuel Pressure Limiting Relief Valve #bosch common rail high pressure relief valve #bosch diesel pressure relief valve #bosch fuel rail pressure relief valve #Buy Fuel Pressure Limiter Valve #Buy Fuel Rail Pressure Relief Limiter Valve #common rail diesel pressure relief valve #common rail fuel pressure relief valve #common rail pressure limiter valve #Common Rail Pressure Relief Valve for Denso #common rail relief valve #Common Rail Valve #cummins common rail pressure relief valve #cummins common rail relief valve #Cummins Diesel Fuel Rail Pressure Relief Valve The merits of the common rail fuel injection system architecture have been recognized since the development of the diesel engine.

Lower fuel pump peak torque requirements.

As high speed direct injection (HSDI) engines developed, more of the energy to mix the air with fuel came from the fuel spray momentum as opposed to the swirl mechanisms employed in older, IDI combustion systems.

Only high pressure fuel injection systems were able to provide the mixing energy and good spray preparation needed for low PM and HC emissions.

To generate the energy required to inject the fuel in approximately 1 millisecond, the conventional distributor pump would have to provide nearly 1 kW of hydraulic power in four 1 ms bursts per pump revolution, thus placing considerable strain on the drive shaft.

One of the reasons behind the trend toward common rail systems was to minimize the maximum pump torque requirement.

While the power and average torque requirements of the common rail pump were similar, high pressure fuel delivery is to an accumulator and thus the peak flow rate (and peak torque required to drive the pump) does not have to coincide with the injection event as is the case with the distributor pump.

Pump discharge flow can be spread out over a longer portion of the engine cycle to keep pump torque demand more even.

Improved noise quality.

DI engines are characterized by higher peak combustion pressures and, thus, by higher noise than IDI engines.

It was found that improved noise and low emissions were best achieved by introducing pilot injection(s).

This was most easily realized in the common rail system, which was capable of stable deliveries of small pilot fuel quantities over the entire load/speed range of the engine.

Company Contact:

• Posted By: china lutong parts plant

• Phone: 15160469662

• Address: Dufeng hanjiang putian Fujian China, putian , Fujian , China

• Email:

• Website: http://www.china-lutong.net

• Business Description: This is Mandy from China lutong parts plant.
  
  We are specialized in head rotor ,nozzle,plunger,delivery
  
  valve,injector,control valve,C7 and C9 control valve,yamar head rotor，test bench
  
  My whatsapp is : +86 15105944581
  
  phone number/wechat: +86 15160469662